[root@magnia root]# dmesg
Linux version 2.4.18-3custom (root@rh7_2builder) (gcc version 2.96 20000731 (Red Hat Linux 7.3 2.96-110)) #3 Wed May 29 15:52:38 PDT 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000010000000 (usable)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 65536
zone(0): 4096 pages.
zone(1): 61440 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=linux ro root=301 BOOT_FILE=/boot/vmlinuz-2.4.18-3custom
Initializing CPU#0
Detected 568.667 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1133.77 BogoMIPS
Memory: 255944k/262144k available (1129k kernel code, 5816k reserved, 789k data, 272k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Celeron (Coppermine) stepping 0a
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb360, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router VIA [1106/0686] at 00:07.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.5.0 initialized
Detected PS/2 Mouse Port.
pty: 512 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
block: 496 slots per queue, batch=124
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xc000-0xc007, BIOS settings: hda:DMA, hdb:DMA
hda: IC25N020ATCS04-0, ATA DISK drive
hdb: IC25N020ATCS04-0, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 39070080 sectors (20004 MB) w/1768KiB Cache, CHS=2432/255/63, UDMA(100)
hdb: 39070080 sectors (20004 MB) w/1768KiB Cache, CHS=2432/255/63, UDMA(100)
ide-floppy driver 0.99.newide
Partition check:
hda: hda1 hda2 hda3 hda4 < hda5 >
hdb:
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
ide-floppy driver 0.99.newide
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 272k freed
Adding Swap: 120448k swap-space (priority -1)
NET4: Ethernet Bridge 008 for NET4.0
Bridge firewalling registered
8139too Fast Ethernet driver 0.9.24
PCI: Found IRQ 10 for device 00:08.0
eth0: RealTek RTL8139 Fast Ethernet at 0xd0833000, 00:10:c6:10:73:1f, IRQ 10
eth0: Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.
eth0: Promiscuous mode enabled.
device eth0 entered promiscuous mode
brg0: port 1(eth0) entering listening state
Intel(R) PRO/100 Fast Ethernet Adapter - Loadable driver, ver 1.6.6
Copyright (c) 2001 Intel Corporation
PCI: Found IRQ 11 for device 00:09.0

eth1: Intel(R) PRO/100 S Server Adapter
Mem:0xd5021000 IRQ:11 Speed:0 Mbps Dx:N/A
Failed to detect cable link.
Speed and duplex will be determined at time of connection.
Hardware receive checksums enabled
brg0: port 1(eth0) entering learning state
brg0: port 1(eth0) entering forwarding state
brg0: topology change detected, propagating
ip_tables: (C) 2000-2002 Netfilter core team
ip_conntrack (2048 buckets, 16384 max)
Loading Lucent Modem Controller driver version 5.97a
Lucent Modem Interface driver version 5.97a (2001-01-26) with no serial options enabled
ttyS14 at 0xd800 (irq = 5) is a Lucent Modem
build.time='Jul 29 2002@ 11:48:54'
reg_chr() CC = 0!
__Open() - start!
ProductName = MAGNIA SG20 Len=11
SerialNum = 82207270A Len=9
driver.via( set 'disk.1.present' = 1 )
driver.via( set 'disk.info.1.percent.free' = 91 )
driver.via( set 'disk.1.free.mb' = 14623 )
driver.via( set 'disk.info.1.smart.status' = 0 )
.fan.cmd = < fan.sys.on >
Turning SYS Fan on
.fan.cmd = < fan.cpu.on >
Turning CPU Fan on
driver.via( set 'disk.2.present' = 1 )
driver.via( set 'disk.info.2.percent.free' = 100 )
Linux Kernel Card Services 3.1.22
options: [pci] [cardbus] [pm]
PCI: Found IRQ 12 for device 00:0b.0
Yenta IRQ list 0200, PCI irq12
Socket status: 30000007
.fan.cmd = < fan.sys.off >
.fan.cmd = < fan.cpu.off >
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
driver.via( set 'disk.2.present' = 1 )
driver.via( set 'disk.2.ext2' = 0 )
driver.via( set 'disk.1.present' = 1 )
driver.via( set 'disk.2.present' = 1 )
driver.via( set 'disk.1.ext2' = 1 )
driver.via( set 'disk.2.mirror' = 0 )
driver.via( set 'disk.1.mirror' = 0 )